71hls30

hello datsun z owners. I have the MSA carbon fender flares for sale. i purchased them awhile ago before realizing that i would have to cut the actual bodywork. Since my datsun is a low vin and early 240 i do not want to ruin it. i am looking to get at least 400.00 which is cheaper than the 430. plus tax they are asking for. I live in the san fernando valley in southern california.. you can email me directly at whtecivic@aol.com for any questions. Thanks for reading i also have a full set of autometer guages the pro lite i think .. They are silver.. The tach, speedometer oil volts and water temp i am asking 300. including the harness.

Wow, you are awesome!! Thank you very much for quick and informative response..

Hi thanks for reading. I am trying to figure if i can re-route the brake lines from master cylinder to proportioning valve. ( instead of to the bottom of valve, i want to run directly into the top by the brake switch.) I would like to attach a pic. But i don't think i can. Will running the lines to the top make the brake lights stay on.. any advice would be helpful.

Yeah cool show. I saw him at the mitty last year with his datsum. Nice guy down to earth. If he did do top gear usa i would watch it.. sally from the car show does not fit in though..

From what I understand is cutting half a coil will result in ATLEAST one inch of drop. I would be careful. You should take your time and start with a half coil reinstall it and drive around the block and re-measure

Hello i am new to the site. I forgot to mark my lower control arms. I am replacing the lower control arn bushings with poly. And the bushing has a metal stud. Does it protrude towards the front or rear when installed