Datkid

I'm actually immobile at the moment, if you are still intersted please contact me via phone. 425-346-7647 Kenneth

Ok for the whole thing I'll have to package it up and take measurements. I'll get back to you guys.

just the knob? like 5 bucks

Its a plastic knob and its 4 speed pattern

free 620 steering wheel and manual trans shifter 620 radiator no leaks-30 620 l20 coil- 20 located in everett,wa. Kenneth 425-346-7647

He skipped step one all together : obtain drivers license.

I have 4 14x6.5, 4x114.3 black enkei mesh with junk 195/75r14 tires for sale. very very minimal curb rash on one wheel that isnt bad at all.could use some polishing and paint. pictures of wheels are on an s12 for reference. Looking to get 300 obo 425-346-7647 Kenneth

lots of work this weekend. should be running in the next couple days. Body still needs paint, i know i know.

I still need to notch passenger side to get the piping a little more flat and weld the bov flange on but thats decent progress. I also cut an old muffler off and welded a new one onto a 69 dime in the middle of it all.

its a tight fit but its in there. tomorrow will yeild mounts and fmic mounting.

^ my datsun is more important right now. I still need to order fuel pressure regulator and fmic couplers. today i pulled flywheel/pressure plate,clutch and replaced throw out bearing and pilot bushing. should get flywheel back tomorrow afternoon to reinstall and start fabbing up motor mounts

haha ya. i picked up a running 86 200sx with front corner damage with this ca18det with greddy profect b boost controller,fmic and sr t25 for $1000 to replace the ka24e

prep/paint bay and clean new motor

pulled the blown ka24e out and started pulling the new motor from the doner car.

negotiated the purchase of a new power plant after blowing my ka24e 2 days ago