Jump to content

620doof

Members
  • Posts

    42
  • Joined

  • Last visited

Profile Information

  • Location
    Washington
  • Cars
    92 Maxima se, 79 620
  • Interests
    I love Nissans and the outdoors.

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

620doof's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. 620doof

    1977 620

    Yeah I'm drooling.. Someone put some LOVE in that thing, holy crap. Pics of the engine please!
  2. Ahhhh man. So am I going to have to get a steering wheel puller to get the wheel off then i'm guessing? That's a big hassle for some lights! Darn. Oh well, next couple days off I'll try and get to it. Thank you sir!
  3. Finally got my girlfriend to help me. It actually does NOT go completely out. If the turn signal is going, it stays blinking. If the tail lights are on, the tail lights stay illuminated on that side, but do not brighten when you hit the brakes. So I should inspect the wiring at the turn signal switch then?
  4. Darn, ok. I will have to double check but I'm pretty sure that side just goes dark. No lights at all. I will have my girlfriend help me when shes up to see exactly whats going on. Thank you though.
  5. On the drivers side, when I hit the brakes that side goes out completely. But the tail lights and turn signal works fine. I checked the wiring, it looks fine. There's a 4-pin trailer harness but it seems to be wired correctly. I cleaned all the grounds I could find. But while looking for change(for a mc chicken) I found this behind my seat: The two black wires coming out of the connector are cut, just bear wire. Here's a close up of the wires coming from under the carpet: Do these have something to do with the brake lights? It looks like it may come off the bundle of wires that runs up the frame rail and then into the cab. Any help would be appreciated!
  6. 620doof

    L20ET into 620?

    Thats what she said.
  7. You should paint that front valence! Tape everything off one day then you wont have to worry about it again
  8. Damn... The wiring on that thing would have scared me off. GOOD LUCK though! :)
  9. It appppppppears to be pretty rust free. That would be a plus. I've spent a lot of time chasing down all my rust.. it was a big pain in the butt. But wiring issues could be a big pain on this if there is any. Check the wiring, floor boards, fenders, and bed for rust also.
  10. Awesome sounds very simple. Thank you thank you!
  11. Where exactly do I find a bearing spacer? Or is it something that needs to be fabbed?
  12. Hey Mike is it normal to have the choke adjusted that far to the left(rich)? Like in that picture, mine was centered on the dot. Or is that just an example pic for the OP?
  13. I bet you he has a lisp "wather pump"
  14. L20b is basically an l24, l26 or l28 with 2 less cylinders ^^ I bet that Z shop could figure it out, haha.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.