Jump to content


Member Since 29 Nov 2010
Offline Last Active Yesterday, 04:12 PM

Posts I've Made

In Topic: temp sensor to match stock PL510 temp gauge

01 July 2016 - 08:42 AM

Thanks, everyone!



In Topic: Front 280ZX Brake Problem

20 April 2016 - 08:25 AM

The result of this brake problem was the removal of the small spring clip that's riveted to the back of the inside brake pad.  The rivet caused the brake pad to skew sideways & bound up the rotor.  Removed the rivet and all is good.


As a side note, I acquired an extra pair of new speed bleeders for stock rear brake cylinders which I can't use because I have the complete 280ZX braking system on my 2dr.


If any one would like these for the cost of S&H, please LMK at the email below.




In Topic: MemberCan'tReceivePM

28 February 2016 - 10:03 AM

Thanks Mike.



In Topic: help guys suggestions, opportunity arrived 4 me..

28 September 2015 - 09:49 AM

Get the parking brake assembly too, including the handle, it's pedestal and bridle.


Send me your email address and I'll send you my DQ article on the 280ZX brake upgrade.