deans510

Thanks Mike, I'm using the fiber disc from the D21 assembly but the PP is way bigger in diameter than either FW. Dean

I have 2 Fidanza FW's, 229501 for a Skyline R33 2.5L 93-98. The other one, NIS3-6621 143P that I've had in my 510 2dr btw '89 KA24 engine & stock KA 5 speed. Both of these are 240MM. The 229501 has a new friction disc on it, but I can't find a decent street clutch set for it. Most of the cheapest ones are in the $500 to $600 price range & go up to over $1500 for racing clutches. I would like to use a clutch set for around $250 or less. I've also come up dry for a new clutch set for the NIS3-6621 143P in that price range, any ideas? This is the FW I'm going to have to use. I'm going to sell the 229501 because there seems to be only racing high $$ clutches available for it. Someone with an R33 may find it good for them. Any help would be appreciated. Dean

I need advice on what would be a good non racing, street only clutch set for a 240mm Fidanza FW I'd like to use with my newly rebuilt Rebello KA24 engine and trans. The KA24 engine and trans I'm replacing has a 225mm Fidanza FW clutch set. Dean gzentas510@outlook.com

Thanks, everyone! Dean

I have a stock PL510 temp gauge but its connected to a temp sensor (thermistor) on the KA24 engine swapped into my 2dr. I don't have any movement on the gauge with this combination. Anyone know what the correct sensor is for the stock PL510 temp gauge? Dean deans510@gmail.com

The result of this brake problem was the removal of the small spring clip that's riveted to the back of the inside brake pad. The rivet caused the brake pad to skew sideways & bound up the rotor. Removed the rivet and all is good. As a side note, I acquired an extra pair of new speed bleeders for stock rear brake cylinders which I can't use because I have the complete 280ZX braking system on my 2dr. If any one would like these for the cost of S&H, please LMK at the email below. Dean deans510gmail.com

Thanks Mike. Dean

I've tried to PM several members who have full mail boxes, most recently d-510, and others. Is there some way to contact these members other than PM??? Dean deans510@gmail.com

Anyone know how to contact the above? Tried to send a message but he couldn't receive anything. Dean deans510@gmail.com

Get the parking brake assembly too, including the handle, it's pedestal and bridle. Send me your email address and I'll send you my DQ article on the 280ZX brake upgrade. Dean

Anyone know what the "P" connection is for. The unit I'm replacing dosen't have this connection. Any help is greatly appreciated, TIA Dean deans510@gmail.com

It's possessive,

Well, has anyone fabricated this tool? Or is there a special tool that Nissan offers to do this? Leaving them in is not much of a solution. Dean deans510@gmail.com