So I went for techno toy tuning = t3 coil overs with 150lbs springs. I had already rebuilt the whole front end 6 months ago so I pulled the struts out and tig welded the rings on for the threaded collar stops. I put it all back together in the middle of the threaded sleeve so it can adjuster 3.5" up or down from where it is now. It is a little over an inch lower in the front now from my last set up of ZX struts with stock 510 springs with one coil cut and perches as low as possible. It could go no lower with that set up. Now probably 3" lower in front than stock and 2" blocks in the rear. I added 1" bump steer spacers also. Tires are 185/60/14. Going to drive it for a week, see how everything works and if the height needs adjusting then tighten everything back up and get it aligned. This should be all I need chassis wise. By the way if you are thinking about coil overs, ONLY buy t3, they are made so nice, are great to go way low and the owner is very helpful. See y'all at Canby!