xzile609

Scotty's also did my sr20det exhaust on my 510 great work.

Yea cut flush. Had to tack weld some of the sheet metal just below that center brace I guess that its a C Chanel and not square. It looked square because of the thin metal in front of it. A friend of mine did all the fab work.

Started by cutting out the metal for the inter cooler Cut a piece out of the support looks like this. Did not cut the lower support. Had to clearance the valance Tested the mounting. Looks good, I cut out the metal for the IC the mounting bracket didn't line up like they show in the Ebay page. The bottom mounting brackets did not line up with the 2 large holes. So we welded in a small strip of metal to support those mounts. Then installed the CXracing Radiator just on top of the Intercooler it fits great just above it. Just make sure you leave a gap so that you can get your clamps and silicone hoses attached to the inlet pipies. I also noticed that there was much more room in front of the engine that when I had the KA24de installed. So I was able to install the shroud it came with so happy about there here are the shots of it without and with the shroud for the 2 electric 12inch slim fans. Might not be the best install but I like it alot. Clears the hood no problem.

Ok I installed the Inter cooler and the radiator now my motor and engine bay need alot of work to make it pretty but, im getting it all installed and then ill make it nice so excuse the mess.

I'm about to install the same inter cooler and cxracing radiator in my car this weekend. I will try to put some pics up as to what ill have to do. I don't think you have to cut the frame but you will cut out some of the cross brace area. I haven't actually test fit yet so ill let you know what I find.

Payment sent

Ure mail box is full Im interested in it.

Found this drawing maybe it will help someone?

Ah yes the ron davis 1A-22163

Done allot of searching unable to find a good setup for Inter cooler radiator combos for this swap. Everyone seems to do it different which makes it confusing. they will look nice in pictures but the setup butchers the car pretty bad. Right now the CXracing IC seems to be the easiest to get and install. just not sure about what radiator to use with it. any help/ideas would be great thank you.

Same here lol

I have photos with the stock 510 struts yea they are way past the fender. This is full stock 68 suspension. The stock struts have MASSIVE clearance between the strut housing and the tire. I installed 280ZX struts now you cant get a finger between the strut and tire, it still clears but barely. Untitled by xzile609, on Flickr

This is as low as I could get it without going into flares which may be next installed coilovers all the way around and put in 280ZX struts. Untitled by xzile609, on Flickr

XXR 531 +0 offset 16x8 on Falken 205/40/16

Untitled by xzile609, on Flickr