Jump to content

racer135

Members
  • Posts

    54
  • Joined

  • Last visited

About racer135

  • Birthday 12/22/1990

Contact Methods

  • MSN
    the_real_racer135@hotmail.com
  • Website URL
    http://search Facebook for Sam Meloury

Profile Information

  • Gender
    Male
  • Location
    Booyal QLD Australia (West of Bundaberg)
  • Cars
    '73 B110 4drSdn '78 B210 4drSdn '71 B110 4drSdn '73 B120 '78 B120
  • Interests
    Working on my Datsuns and everything mechanical.
  • Occupation
    Boilermaker/Welder

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

racer135's Achievements

Newbie

Newbie (1/14)

6

Reputation

  1. Been a looong time since I've logged in here. In November? I chucked a 620 grille in the front of my ute And I forgot the stuff around of loading images on forums so no pic
  2. Well done for loading a random unrelated photo. I know how to load photos from photo sharing sites and do all the code to put it into a post. I'd rather not go through all that BS and just be able to hit a button, select the photo from storage, upload it, and then hit post. One day it will happen and forums such as this one will be all the better from it.
  3. Aaaand I can't load it on here with my phone. Well done forum creators for not supporting photo uploads *clap clap* I'll load it onto the Ratsun.net Facebook page
  4. I messaged the owner of the car in the original post earlier in 2015. It's 939, I have a photo of his rad support with it stamped in.
  5. Seen someone who drilled a hole in one of his hinges just above the hole in the firewall when the hood is fully up, and has a big split pin hanging from a chain bolted to one of the bolts which holds the hood to the hinge. Lift the hood and poke the split pin in the hole and it stays up. Not sure why you would want to get rid of the ones in the 510's, I want to put one in my B120.
  6. So how do you keep the bonnet up when working in the engine bay? Or have you got someone on speed dial? :-D
  7. And some of those plugs you might find will fit into the holes in the panels that meet the floor along the sides below the doors
  8. I think you will find the rubber on the turkey basters will swell up when they come in contact with petroleum based oils
  9. Yeah it could have been an AUSDM thing, and I'm not sure what region my parts book is from
  10. I was told all the coupes came with the ones with the big end bit. I should have checked the coupe section of the book in hindsight, it lists whether it's optional for the different body shapes or trim levels.
  11. http://i122.photobucket.com/albums/o277/racer135/20150702_165108.jpg
  12. I never said it was wrong, I just mentioned what the factory use of those holes was.
  13. You can just use an 'E' clip for the wiper linkage onto the eccentric motor shaft
  14. Probably wouldn't be that difficult or expensive for someone to 3D print you one. I didn't look real close at what you made
  15. It will probably sag 1/2", maybe even 1" after driving it around for a few months, depending on the spring rates you're running
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.