Jump to content
28 November 2017 - 02:48 PM
Just heard from Willy, the seller, that the parts are gone.
He was going to put them on eBay but must have gotten an acceptable offer for the lot.
Anyone here get them?
06 November 2017 - 09:27 PM
Here is a write up for the procedure on NICO.
There are two adjustment holes on each gauge. The one indicated adjusts the needle in the hot position.
What you are turning inside the gauge is like a rheostat to change resistance.
Same concept applies to the gas gauge.
The other hole is to adjust the set point where the needle rests when you turn the key off. Really of not much concern and I have not tried it.
06 November 2017 - 01:28 PM
Nice clean up job Eddy. Glad the sender was repairable. Tank inside as clean as it seemed?
The early 60's temp and fuel gauges are adjustable from the back.
You can adjust the needle to sit at the full mark when the tank is full.
Community Forum Software by IP.Board