ChrisGoHard

Link? Thanks for your help

Driver and passenger need new bushings. Driver door sags a good inch and a half passenger side about a half inch. There are replacement hinges on ebay from Japan but I was wanting to know if you all knew of any way to replace the bushings and pins or if I'll have to just fork up the cash for new hinges. Car is 81 B310 hatchback.

Reading through here I know there are a couple things I can use from a 280zx. There's a guy in Tennessee parting out a 280zx and I'm getting the front struts and the brake master cylinder from him. He also has a couple 300zxs he's parting out as well. Is there anything else I should see about getting to make some upgrades? Possibly rear end for an IRS conversion? Tranny swap? Just anything in general I could use? My car is a b310 hatchback.

Guys I have a small problem. I own an 81 B310. The previous owner seems to have cut the front coil springs in order to lower it. The ride is terrible even with new strut inserts. Bottoming out is common with daily driving. Rockauto has new springs listed but they are out of stock. What other vehicles could I pull springs off of to match original ride height and spring rate? Stiffer springs but slightly shorter wouldnt be an issue as long as it doesnt cause the car to bottom out. Thanks for any help.

I have the same year and model and here in Kentucky there is nothing. I've decided to just go with a custom built dash. I will be stripping the interior so if there are any other parts you need I might have them. Interior on my car is in excellent condition except for the damn dash

Ok guys thank you for your help.

Ok I found a guy parting out a 280z. Not a 280zx. Is there any difference between them as far as strut assemblies?

A local junkyard has a 240z. I was wondering if the front struts are the same as the 280zx struts as that's what everyone seems to recommend using to upgrade the front suspension.