Jump to content


Member Since 08 Jun 2017
Offline Last Active May 17 2018 10:38 AM

Topics I've Started

KA24DE T25/T28 Turbo Manifold

28 February 2018 - 09:51 AM

Probably a project for later in the year, but just brainstorming on ideas to boost the ol' KA in the 1969 dime with a T25/28 off an S13/S14.  Planning on a very mild  setup so i think a T25/28 with internal wastegate should fit the bill.  If i can get close to 175-200hp at the factory 7-8psi I'd be very happy.  


My main hurdle (probably the same problem with all 510's with KA swaps who want to boost) is the manifold.  I'm open to any and all ideas at this point, but i was planning on getting a 240sx (ka24de) bottom mount SS tubular manifold with T25 flange from eBay and see how much I'd need to modify it to make it fit.  I have zero welding/fab skills, so any alteration will most likely be going to a local muffler/fab shop.  Hoping the small(er) T25 with internal WG will fit as a bottom mount with this manifold with minimal modification.  Anyone have any insight here?


The other option is a top mount cast manifold with a T3/T4 flange.  I know this has been done many times before, but I'm thinking a T3/T4 might be overkill for what I have planned.


Of course I'll also be upgrading the fuel pump, injectors, MAF, ECU and all that other good stuff. 


Looking forward to everyone's input!  Thanks. 

Recommended Shop to Install 510 Rear Camber/Toe Adjusters- SoCal

12 January 2018 - 08:32 AM

Hey fellas, does anyone have a shop recommendation in the Los Angeles area that can install a set of rear camber/toe adjusters on a 510?  Appreciate the help.  

1969 Gas Tank Venting

06 July 2017 - 06:00 PM

Hey guys, I have what appears to be a late 1969 gas tank in my 2-door 510 with two ports on top.  Currently, the larger of the two (on the passenger side) is connected to the filler neck which appears to be correct.  But the smaller port in the far driver side corner is also connected directly to the filler neck.  Am i missing an evap tank?  Anything wrong with the way it is currently set-up?  I also have a non-vented gas cap.  Thanks in advance, appreciate the help.