Jump to content

jjwoodmaster

New Members
  • Posts

    4
  • Joined

  • Last visited

Profile Information

  • Location
    San Diego California
  • Cars
    1978 B210
  • Interests
    Automobiles Hiking golf

jjwoodmaster's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Hello, I picked up this motor. Has never been installed or fired up. Can't find any specs on the motor. It came with a 728 head round port head. Should I run that head or throw an available H95 Oval port head. I have either intake manifold so that isn't a consideration. Looking for what power I can get as it is going in front of a 3N71B in deference to my daughters who are clutch impaired. Thanks, John
  2. That was my thought which is why I asked in the first place
  3. No it isn't. I have since learned from Peter Z the misalignment of the gasket to these holes is normal. Thanks
  4. Hello, currently putting together an A14. What I find is the two water jacket holes (per cylinder) next to the push rods in the head gasket are not aligned with the holes in the block. The head gasket partially blocks these holes.Is it typical for the head gasket to not align to these holes? Thanks, John
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.