Jump to content


Member Since 12 Mar 2017
Offline Last Active Mar 08 2018 12:54 AM

Topics I've Started

200sx z22

25 February 2018 - 12:57 AM

Need help figuring out why the engine will start right up runs and idles fine for about 45 seconds then dies.. then I have to wait about 20 minutes and it start a back up and runs for 45 seconds then dies again..

82 200sx z22

24 February 2018 - 12:47 PM

So I just came up on a 82 datsun 200sx with the z22 fuel injection. I can get it to start just fine the first time it revs and idles fine but after about 30 40 seconds it jus does and won't start back up for about 15 minutes. Can someone e point me in the right direction

L20b 86mm pistons

07 December 2017 - 01:06 AM

So I have a 79 l20b I just got done installing 86mm pistons in it and I replaced all the crank bearings as well. Everything other than the pistons bearings and rings carb headers and dissy are stock (engine wise) I can get it started just fine I can get it to idle also, but it has a slight stumble wile idling and it stumbles pretty bad in lower rpms. Can anyone help me figure out why it's stumbling and won't run smooth...

720 drift truck project

12 March 2017 - 03:15 AM

So I have a datsun 720 I'm slowing trying to build into a drift truck so fare I have replaced all ball joints all suspintion new clutch new break calipers and rotors made for d21 hard body put drop spindles on it and I'm in the middle of c notching it it is my daily driver and I do not have any other vehicle at the moment I do not know much about building any vehicle but I'm learning as I go with Weeks of research before doing most things.