Djditty

Anyone running a J series trans on a E motor? If so, how? Haha!

Hello all! I'm looking to convert my column shift NL320 to floor shift and I am in need of all parts for this swap. Please message me with anything you have. Thank you!

So I have a question for those of you who are more schooled in the ways of the 320. Does the engine and trans need to be pulled or can the trans be dropped out the bottom without pulling the motor? Thanks!

Wayno you have PM.

Haha! I've heard about that trick. Guess ill just have to give it a shot. Thanks guys!

I'm wanting to get wide whites for my NL someday and was wondering if anyone has done this, what size they purchased and where they purchased them. Thanks!

Excellent! Well not knowing to much about transmissions I may have to take it somewhere to have it cleaned up. Unless you can give me any advice or a service manual that would show that process. Thanks.

Column shift.

Hey Wayno. I have 1st and 2nd but I can't shift into third unless I'm pretty much at a stand still or stopped all together.

Does anyone know if the internals of a 320 column shift tranny are the same as the internals of a floor shift?

This is what I wanted to do with my 320! Can't wait to see the progress!

NL320 rear quarter panels!!!!

Ah bummer! Any NOS parts really. Haha! I would love to have some drivers door chrome trim and some new blinker lenses for my front grill.

Hey do you still deal in new 320 parts? I tried to PM you but it wouldn't go through. Thank you.

I'm in!