Posted by mainer311
on 01 December 2017 - 03:20 PM
That’s about as high as mine ever gets now, after I drilled an 1/8” hole in it. The line is basically the “warmed up” mark. Since October, it never passes the line. In the summer it will go a little bit past.
I feel your pain. Get people interested, that's the key. I have business related threads going on other forums and I work hard to keep my followers interested. But then, I have a business to promote, so I work pretty hard at it.
Which should all be in one thread. You keep looking new, with every post. Stop doing that.
If you come up with a cool discovery, make a How-To. But every single nut and bolt does not need its own dedicated thread.
You should start a new thread telling people how-to not start a new thread every time they have something to work on.
Oh and dp, I’m pretty sure I have that choke cable x2.
All I am saying is turn your motor with the dizzy cap off and see what happens. On mine only one set of points ever opened which would make that set the primary no? And I don't remember what else didn't 'fit' with the pertronix but I seem to remember the magnet collar thingy not fitting right.
I did when I had my dizzy out a few days ago to free the stuck pedestal. Both points open at the same time.
If one of your points wasn't moving, something was either wrong with it, or that sets of points was adjusted far enough out that it wasn't being contacted by any of the lobes. The points open and close mechanically.