Jrüdorf

And like I said, once I shut it off when it's hot. It will not start again. Which, is Vapor Lock.

So, neither my Original Hitachi nor the Replacement have the window on the bowl. There is no gasoline overflowing the bowl.

Ching was 60 Dolan in the end. I can't afford any of that nice shit. Anyways, the problem has been ruled into the catagory of a Vapor Lock. So what do. As for condition, it was a Fairbanks special. Bits of duck tape and zip ties everywhere, White shag carpet floor mats on a painted fooor pan. Wiring harness stripped to Bare Essentials when I bought it.

Yeah, all plugs and wires are good and go to the right place. The truck has 350,000 miles and those were the original coils. It was Very obvious they needed to be replaced. The housing was rusted through on one coil, the other had rust and was deforming from heat. It was stolen and driven less than 300 feet. I had eyes on them the whole time. Metal expands when hot and contracts when cold. It was -30 outside, my engine was FRESHLY started, like ran for 10 seconds. It takes 30 minutes of Idleing before the engine is warm enough to drive without damaging the engine here in Alaska. Bitch jumped in it as soon as I started it and walked back inside because it was ColdAsBalls, 'feel me? She floored it, to the point where when it was leaving my driveway it sounded like it was running on One piston. Now, whenever the engine gets warm, it acts like a pile of dick. And if it is shut off while warm, it turns over, but won't start. After 3 or 4 revolutions it will back fire, with the equivalent blast of a .30-06 which, in Alaska, makes people draw firearms at you because they hear a gunshot. Not a backfire, because no one drives Chitty carbenated rigs.

I have a 1985 Z24 backed with an Automatic transmission Fleet Owned 720. I had just replaced all 8 spark plugs, wires, both ignition coils, cap and rotor. She was running like a dream..when the next day she was stolen almost imedietly after I had started her, so she could warm up, seeing as how it was -35°F outside that day. After getting my truck back, it wouldn't stay running smooth once the engine became hot. (Standard running temputure) first start of the day, everything would be fine, until it gets to running temputure, then it develops an intermittent random sputter, almost akin to a Misfire. If I shut the engine off while at running temp, it will not restart easily. The engine will crank, but it acts like it is flooded and can't breath. After a few seconds I stop, wait a few minutes, and try again. It will come to life after sounding like a .38 cal was fired- (cops have shown up at my house multiple times since my truck was stolen, "responding to gunshots" and I'm like "you guys have my gun in your evidence locker, the sound reported was my truck") -it will run with coaxing (holding the pedal down 1-200 RPM higher than flat idle) at stop lights it will cut out upon acceloration almost as if it is not getting enough Air. Now, mind you, this is only while the engine is hot, or warm. Dead cold, (several hours of sitting dormant) it starts right up and runs like a dream, until it gets hot. I decided with help from the Nissan 720 Shop Manual the first step was to check the Carb. I saw that the plug was still covering the mixture screw, so I decided to check the rest of it. I found the accelerator cable was stretched 4cm. I found an armature sheered off, and the diaphragm in the Auto Choke was shot. I decided that the best thing to do at this point would be to purchase a new one, being the broke ass northern'er I am, I bought the Ching Brand off FleeBay. seeing as how the truck is a proud member of the Quarter Milion Mike Club, by having 350,000 miles on it, I was not going to be assed into buying a 3-400$ Weber. So, new unit came in, and I noticed several small differences between the Hitachi and the Ching. The Ching has No emissions system parts, like fuel air ratio sensor, a few vacuum lines and a breather line. So I installed plugs on the other vacuum units in the truck that connected to the carb, and then fired her up. After 20 second I smelled a Lot of gasoline, and the truck started acting bogged. I immediately killed it, jumped out and inspected the engine, gasoline everywhere from the top of the carb. The float was stuck open allowing the fuel pump to continue filling the bowl. I removed the new carb, brought it back home adjusted the float and now I'm wondering if anyone else has used the OM Replacement style carb. I'm also wondering if my trucks electrical system is confused since the Hitachi has several wires in its harness going to different seonsors, but the Ching only has 2 wires, one being red, going to the anti deiseling solinoide, the other being Blue and going to the auto-choke. Also, I'm wondering if anyone out there has any Hitachi parts laying around, mainly the cover for the float. Ching brand comes with a Flat Float Cover, without the window. My Original Carb, also, was missing the window, as if someone had already once worked on it previously and replaced the cover. 1985 Z24 720 Automatic Regular Bed Standard Cab Bucket Seats 350,000 mi.

Just bought a tired 720 for 1,000 less than what the craigslist ad wanted. 333,000 Miles and still ticking, original engine 2.4 ltr, with 3 speed auto trans. The interior has been eaten by a dog, there is a rouge spring that attacked my jeans the other day, And the carpet is a white shag...I've been trying to tidy up the mess of spaghetti electrical the previous owners left for me, but my biggest peeve is the Indicator assembly for the Transmission is smashed, so I have to guess if I'm in drive or 2 or n. So on and so forth. Alrighty, anyone know where one is? I'm in Alaska so "pick and pull" and "salvage yard" are out of the question, I done already looked. (I made up an indicator out of a piece of tape with sharpie...this will only do for so long) -Jrüdorf