Jump to content


kelowg

Member Since 28 Oct 2007
Offline Last Active Today, 03:39 PM
-----

#1571001 Datsun BBQ......July 28th....12-whenever..........

Posted by kelowg on Today, 03:41 PM

Havent ck'd my on call sched. So hopefully




#1570931 82 720 very low oil pressure

Posted by kelowg on Today, 06:02 AM

Ka pump, if not from dealer. Not always the actual ka pump. Aftermarkets just sell up stock Lseries pumps for everything.




#1570930 82 720 very low oil pressure

Posted by kelowg on Today, 06:00 AM

Looks like maybe a piece of gusset/rib. Doesnt look machined,but not in itself ur issue. Did i miss it,but what oil and weight r u using?




#1570436 Speedometer pinion assembly

Posted by kelowg on 17 June 2018 - 06:01 AM

I well say,using turn by turn gps just makes u stupid. I use google maps,just i did with paper ones. This way helps u learn the area ur in. My wife uses turn by turn and makes wrong turns. She cant go anywhere out of town without,even places she has been several times




#1570126 Speedometer pinion assembly

Posted by kelowg on 15 June 2018 - 05:51 AM

Just get a gps speedo gauge,lol.

No more guessing,broken cable or pinion gear.

Or just use phone with gps app and leave stock setup be.




#1567486 Pinging under power and drive train Q's

Posted by kelowg on 30 May 2018 - 05:19 AM

Shaved head may up compression ratio to a degree. Higher octane helps reduce pinging. Too advanced timing adds to pinging. Verify running temp with temp gun or other quality device. Do this before any thing else, Oem gauge could b off.

As they say,check the stupid shit first. Otherwise you well just make things worse,ie "melted head"




#1567402 Speedometer Cable question

Posted by kelowg on 29 May 2018 - 03:13 PM

To remove inner cable,u have to disconnect at trans. U spray lube down cable housing but likely get all the way down it.




#1566791 620 king pin discs pls

Posted by kelowg on 26 May 2018 - 06:36 AM

Or go with the wilwood setup,it on ebay right now




#1565100 Datslocos Cali 14th Annual Carshow/Swapmeet May 19th 2018

Posted by kelowg on 18 May 2018 - 10:59 AM

Traffic is always heavy,depending on where exactly ur goin. There is always more than one route u can take.




#1564183 Heres yet another 620 4 to 5 speed trans question..

Posted by kelowg on 14 May 2018 - 07:50 PM

3.89 gears .075 od on 16's with stock l20b works great for my truck. 18-22 mpg at 70-80 mph at 3300-3400 rpms




#1564181 Upper control arm fulcrum

Posted by kelowg on 14 May 2018 - 07:44 PM

Dont think thats a seal,but 40 odd yrs old grease. The grease in my wiper motor was more like epoxy than grease.

Oem i thought was like felt washers?




#1563809 620 Tranny swap

Posted by kelowg on 12 May 2018 - 05:25 PM

Remove clutch and p/p for bit more room. It can b done but biggest pita ever. Torsions do make it easier,tho ill just pull motor next time a round.




#1563413 1991 Ka24de Can am Wiring Help.

Posted by kelowg on 10 May 2018 - 06:17 PM

Ck ur grounds. Clean harness plug connections. U sure dizzy in correctly?




#1563409 75w90 gl5 for 4 speed manual gearbox??

Posted by kelowg on 10 May 2018 - 06:09 PM

Royal purple,sta lube r yellow metal safe. Pensoil syncromesh works too, but bit on thin side.




#1562654 Datsun BBQ......July 28th....12-whenever..........

Posted by kelowg on 06 May 2018 - 04:36 PM

Bump