85Nissan7204x4

Yea I got por15 ready I took the sound detening off the floor im gonna start tac welding new metal in soon I'll take some pics once I'm finished

Yea I pulled all the carpet up and started grinding out the rust. I have rust on both front body mounts pretty bad. I know how to weld I may just patch the few spots I have and maybe slip a piece under the floor over the body mount weld it in and just leave the carpet out and rhino line the floor to seal it up. Yea the floor pan was 707 shipped to me so I'd rather try and do it myself. It's the body mounts where it bolts up to the floor I'm worried about.

Hi i am looking to repair the rust on my truck its a 1985 nissan 720 4x4 extended cab. I can't seem to find any place that sells replacements for the floor panels anyone know where i can buy new ones for my truck or would i have to make my own?

What rims can i use. I found some pro comp 15x8 with a -19mm offset. I don't know what offset to get to run the 31s

I just installed a lift kit and bought new 31x10.5r15 tires. I don't think it will fit on my stock steel rim. I think chevy rally 4x4 rims are 15x8 with a -12mm offset. Has anyone run these on their trucks with 31s?

Okay cool but i been reading people running 33s without a lift and just a body lift. I may cut the fenders and weld the lip of fender up higher so it looks oem still and have more clearance.

Its a new kit. With extended control arms and shackles in rear. The kit says 1.5 to 2.5 inch for me i guess by adjusting the torsion bars

Okay i have an 85 720 4x4 i am installing superlift suspension that gives it 2.5 to 3 inch lift. I was wondering if 33x10.5r15 would fit without any issues?

this is a picture of it. Does the hole look too big for the sleeve.

Hi i have a 1985 nissan 720 i been fixing and im doing a lift kit. When i removed the lower control arm the hole in the frame where the metal sleeve and bushings go looks to be eaten away from previous owner not changing them. content://media/external/file/43982. Is the hole in the frame suppose to have the metal sleeve fit tight? Im just trying to figure out if the hole got eaten away and if i need to have it welded.