Hey, I've already posted a few times getting stuff worked out so she's drivable. It was my sister's truck that's been sitting for 6 years, just got her running again a few weeks ago.
Replaced cap, rotor, plugs and wires and adjusted the valves. I also replace a crap load of toast/nibbled vacuum lines. I Just got home from a shop cleanout, but here she is:
She's been abused a bit by a deer, some brush, a dog standing on the hood and being sideswiped while parked, but in pretty good shape considering. The plan is the olive for the entire truck and black for the trim. Are the markers the same 2wd and 4wd? They both need to be replaced and I'd like to skip the step of painting the chrome for now. I would like to eliminate the stock front turn signals, also. Is there a guide to wire a dual-filament socket in the corner lights?
She started with the stock 14" steelies with some toast tires, so I scored these old chevy steelies and stole the almost new tires off my 2wd Toyota project, cleaned them up and painted them bronze metallic...kinda hard to make out in my crappy cell photos but it's pretty sweet. I'm looking for some centers for them, bullet or cone tip. 4.25" center hole, 4" deep max. Anyone have any ideas?
And she had some rats living in her for a bit. They ate their way in through the shift boot. Is there a similar aftermarket boot that fits somewhat the same, anywhere?
The plan is to run fuel only megasquirt and 1bbl GM TBI. I haven't been able to find anyone who has done this, Any links?
That's it for now.