datson35

I got it fixed it was the reverse shifting fork now it shifts great! Now for the past 2hrs I been trying to get that tranny back into its place but nothing.

I got the Transmission apart ant the gears seem fine no noticeable damage, but the I don't know what is called that holds the gears is loose and dint know how to go about tightening it. I found a replacement at a junkyard getting it this weekend. Tried to post pics but I'm on my mobile and can't figure it out. Anyone one know how to tighten it?

I took the transmission out and weird thing is when I put it on the work bench it popped outta gear and is shifting again? Is that an ok thing or should I be worried if I put it back in would happen again? Should I risk it? I called all the local junkyards and they don't have my transmission model.

I took the transmission out and weird thing is when I put it on the work bench it popped outta gear and is shifting again? Is that an ok thing or should I be worried if I put it back in would happen again? Should I risk it? I called all the local junkyards and they don't have my transmission model.

Dumb question but it could be caused by low gear oil? Just check it and it seem pretty low.checking all my options before I take out the tranny.

I know that's a lot of bolts and saw i have a divorce transfer case yay me there goes my week lol.

I really don't wanna pull the engine and tranny up from the top their so many wires and tube to deal with. I'll take my chances from the bottom but just saw a cross member welded to the frame! That made my day worse.

No it's a 4x4

Is their anyway I can fix the transmission inside the truck? Just cut up the floor board and address the problem? Or would it have to be fully removed? Only reason why I ask is that i don't have floor jack.

So my only option is replacing or rebuilding.? I'm not really tech savy with transmissions is ita real hassle to take it out n apart?

I meant push the clutch it just to push it off the street that's the only way it'll go forward. And that didn't work its like stuck.

Hey guys how's everyone doing. I got another problem on my truck is an 86 kingcab manual that won't shift out of reverse. before it would just stick til I roll back a bit then quickly shift to first that's what usually worked. Though note it won't shift out of reverse. I had to push the clutch in and pick it off to curb any help would greatly be appreciated.

Dang ok will I'm looking into getting a new one right now thanks for the input guys now comes the part of taking it off is ita hassle? Or is it straight forward.

Hey guys/girls I got a problem my ac compressor is shot is their anyway in rebuilding it? Don't really feel like dishing it out $300 foot a new one. Any suggestions with help thanks.

Cool thanks this really helps me. I'll post results when I'm done.