DarkStar620

Slow going, had more snow and rain than usual here in Vancouver, BC. The weather is starting to clear up and me and my dad are gonna start back up on it!

Been following your IG page of this build from the start! Can't wait to see more of it on here.

Been a little while but thought I would update. Started off with the bed. Not sure where to even start on repairs for this. New bed? Engien bay primered Engine bay painted Also one of these are laying around the garage. Kinda thinking about putting it in the 620... Will a 280zx 5 speed work with the KA24E? I mean it kinda leans to the side but thats managable right? Itll bolt up, but will it be a pain is what I am asking.

Hahah my thoughts exactly... Some people, some people just blow my mind. In anyone's opinion, what would you value that truck at?

Guy is nuts right? $25,000 lol http://vancouver.craigslist.ca/pml/cto/5590142035.html

Just a cool $32,000! http://www.kijiji.ca/v-classic-cars/north-shore/1972-datsun-240z-reduced-totally-overhauled-high-performance/1122760436?enableSearchNavigationFlag=true

Leave the bed hooks on!

Imgur.com man!

Ok thanks, and should or shouldn't be to expensive?

Thanks for answering that. I have a few more questions if you don't mind. Would most tire shops be able to bore out the center for me? Do you have a picture with the 17" pathfinder wheels, there are a few sets of Nissan wheels for sale around me, Titan wheels, Armada, Xterra and more Pathfinder ones. What do the ones you like look like? Generally should all the wheels I just listed fit my 620? Thanks for the help.

Hey guys I've been looking at getting some new wheels for my 620 and I'm a fan of the look of these wheels. I have looked all over the forums but I couldn't find these wheels on any 620 and I wanted to ask here to make sure they would fit before I spend $400 on them. If anyone is able to tell me if they will work for my 72 620 that would be great. few measurements. 125mm (12.5cm) offset 15mm (1.5 cm) diameter stud holes Bore is 100mm wide, 55mm deep and 85 mm wide at face of wheel where Nissan cap attaches. Standard width. 7 inch (internal) 8 inch (external) Bolt pattern 6 x 5.5 / 6 x 139.7 Some pics

Thanks for the input guys, gonna play around with the door some more this weekend. Hoping the door is just not aligned properly and that the frame or cab are not bent or warped. I'll try to slide the top hinges back and the bottom ones forward, because as you said from the pictures it defiantly looks like that is the problem. That being said, easier said than done. Its pretty hard getting the door to slide forward, we even elongated the holes on the cab slightly.

I really hope not. I'm almost more curious now as to how bee's starting making a hive in the door lol.

Well me and my dad played around with the door for many hours today, I think we made some progress, I really can't tell. The door still doesn't seem to sit right to me. We threw the old "stock" hinges on and they seemed to line the door up better. Anyone care to share some pics of the side of their driver side doors, and the hinges? Also we found a bee hive in my door today haha! Bee hive With fender not held down With fender held down Passenger not held down Passenger held down Me and my dad are pretty stumped as to why the door sits so bad. Like driver side closes now but there is a huge gap at the fender and the top of there pretty much scraps the top of the cab, which shouldn't happen. Passenger side is perfect, lines are great, opens and closes nicely. Don't get it. Again thanks for the input.