Jump to content

oceanbeach510

New Members
  • Posts

    23
  • Joined

  • Last visited

About oceanbeach510

  • Birthday 05/16/1988

Profile Information

  • Gender
    Male
  • Location
    san diego
  • Cars
    510

oceanbeach510's Achievements

Newbie

Newbie (1/14)

11

Reputation

  1. So just put my motor together got it running and ive noticed that the crank case vent that goes to my intake is whistling and the idle is terrible. If i remove the hose it seems to run better but i know that is not good, so i checked out the hose and it seems to be fine so im kind of lost here.. also i pulled the plugs and they were very black and one actually was wet/ black. any advice would be helpful. thanks!
  2. I tunned the carb when i got the new cam in ( regrind from schinder for that thumpy idle and he gave me the correct last pads) so just need to make fine adjustments
  3. Oh yes now just need to mess with the timing a tad runs just a little rough
  4. I figured it out guys sorry been busy putting it back togather, what i did wrong was put it in the number 2 slot and set the cam on the number one v notch... sad i know but it was my first time! Well anyway i reset it back to the correct settings and fired up the first shot and runs good.. again thanks everyone
  5. So i was just double check eveything and i noticed the number 1 cylinder is on compression stroke and the cams are at 7 and 10 not 10 and 2 anyone have some insight?
  6. Thanks guys, also thanks heinz for the video on youtube it helped me out alot man.
  7. yea its not on olddatsuns.com i already checked
  8. Yea i figured it couldn't be to much sense the head bolts go through them also but thanks for a reassurance!
  9. So I just got my head back from the machine shop and the cam towers where removed, ive searched all all across the internet and i cant seem to find a definitive answer on what the torque settings should be at? Thanks in advance!
  10. Sweet well it has some pitting on it so its going to the machine shop tomorrow!
  11. So I am tearing into my motor redoing the timing chain and all that fun stuff and i noticed my cam is a U20 19 M ive googled all over the place and i cant find anything about the M spec does anyone know anything?
  12. Oh yea I have been working on cars for 10 plus years ( mostly sbc's) I was just commenting on how convenient a video like that is for some of the new people who have never done anything like that before. I know i wouldnt spend the time on making it. and take a complement gesh! lol
  13. Yea i already replaced the motor mounts so prob the wrong pan i think i will just give it a few taps with BFH. Oh also hainz im redoing my timing chain next weekend and i just wanted to thank you for your videos you posted on youtube they where great.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.