dusty_wang

FATBURGER?!?!? What! I miss it so much.

I finally finished installing my Ka24e, stripped all the efi and unnecessary parts to run R1 carbs and lowered the front and rear.

http://www.jhpusa.com/store/pc/viewPrd.asp?idproduct=12171&idcategory=0 This looks like it could be very useful

I have a supercharged 93 Miata and I am considering doing this engine swap along with some other parts from it.

Moroso make one that goes up to 2 inch

this is what i use

Cubes are kinda weak. Check out the Nissan Juke its not available yet. But is pretty awesome looking and the specs arent bad either.JUKE

they look like this

A few companies make a water temp gauge adaptor that splice into the rad hose. I have a Buddy Club adaptor on my car. That may work measure the probe and check if it will fit into an adaptor. They range in size from 28mm to 38mm.

I dont have a pic of them on my dime but i have these. 15x7 +25 205/50 tire

a 510 and a starquest, 2 of my favs