SubwayGUY4

Never had a chance to dyno it. At 8 pounds of boost on a to4e

Ka-t

I let my car rot I haven't even taken it off since...I'll get that up here tomorrow!

Alright I can't find an answer. I know the stub axles on the r160 work in a r180 to use reuse r160 axles so... do r180 axles fit as replacements for r160 axles? I'm asking beccause I broke one in half right in the middle. Kinda trying to get this resolved so I can go to the bayline meet! and r180 axles are all thats local to me. long story short are r160 axles and r180 axles the same?

Well oddly enough other than what I stated in the first post... My latch up front was in perfect position. Lines up correctly along the fenders. It just hits the cowl and yeah mounting points are sunk in. I would do the washer thing to raise it but then the middle of the hood would be way above the cowl.

Before I sell this.., I have a driveshaft that was shortened for a 510 ka swap....unfortunately It was shortened about half an inch to an inch to short for a ka24de swap. Now I'm wondering since the ka24 is one of the longer transmissions, can this driveshaft still be used for any other swap without having to extend it again. Or basically shorten it more for a different swap.

Looking for: Stock 510 driveshaft And 510 68 hood hinges or..... Someone trade me a 69 and up hood for my 68 Prefer local only 100 mile radius from sacramento. 7077181607

Gotcha so... I definetly have a 68 hood with later model hinges which is why the hoods do far back. But yeah, how are you even able to tell the hoods apart.

Hmm I see. So I'm guessing that I have sedan or wagon hood. Is there anyway to confirm that so I can actually find a proper 2dr one next time?

Ok so it's actually 69-73 my bad.

I can't seem to find an answer. Are the 68-69 hoods different from 70-73? I'm having terrible alignment issues. With my hood. I have double plated hinges which means I definetly have 70-73 hinges, but where it mounts at the corners near the cowl, it is sunk in on both sides about an inch. Not to mention it actually hits the cowl when it opens. And weird enough the center of the hood is flush with he cowl. Do you get this effect with 70-73 hinges and a 68 hood?

Yes this picture is what made me wonder if using the stock 280zx ballpoint as it makes it sit higher. I'm basically only doing this for more steering angle

Bump basically all I'm asking is does a 510 balljoint bolt to a 280zx knuckle..

I have a 72 if that matters because i believe 68 and 69 are different so looking for 70+ hood hindge thanks. 707 7181607

Today my hood flew up on me while I was on the freeway, and just bent off from the skeleton the middle all over the place.. Thus.....looking for a hood. Long as its not bent or anything thats coool. 7077181607 Prefered pick up in northern california no more than 2 hours from Fairfield california pleasee