Jump to content

HydroDynamic

New Members
  • Posts

    2
  • Joined

  • Last visited

About HydroDynamic

  • Birthday 01/01/1930

HydroDynamic's Achievements

Newbie

Newbie (1/14)

10

Reputation

  1. On the timing gear, is there a spot marked on the chain and do I jump a link to the next marking on the timing gear and can this be done with only taking off the valve cover? For rpm control, is there a way to govern these engines. Is there a soft rev limiter that the engine can run up against without problems, meaning run smooth not bouncing, or to do continuously. I figure this way will waste fuel but that ok. Propane comes in its own fuel cell/tank no pumps needed, no air in lines or sloshing of fuel in a tank. High octane. Clean. No electronics or computer needed. Very easy to tune, elevation does not bother it much.
  2. I found my way over here. So the motor is out of a 280z 1978 built to 1979 specs so says the stickers. The engine is going to power a hydraulic pump. The pump can only turn 4000 RPM Max and no more, so I will keep it at 3500. The fuel injection is junked and I will run a propane carb. So what do I need to do, and I mean the easy stuff, I saw something about the timing chain?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.