Am pM HooDluM

I was planning on watching pick-n-pull for one. Thought maybe someone local had one kickin around

Thanks for the offer, not going to make it down to canby, maybe we figure some else out.

Corrected the terminology. Thanks for the clarification though.

I have a L16 out of my '70 521 with 4 speed It ran, could probably use a head refresh. Good compression. Shifts just fine. I have a webber carb for it also. Just been sitting my garage for 2 years. $300 OBO or open to trades

Looking for a NapZ Front Half Tranmission Case (aka Bell Housing) for a 5 speed manual

good build, keep posting up the work. I'm pretty much going down the same road.

I'm in process of this swap also. Been searching all over trying to put together a parts list. If someone could clarify what's been used in the form of transmissions that would be great. From what I've been gathering, anyone feel free to correct me, you can use the following? - 280zx trans with nap-z bell housing - ka trans, but requires cutting the shifter hole due to tilt of the KA versus L series Then both require some work on the trans mount and a shorting of the driveshaft. Once again, that's what I got from searching through the random threads, please someone confirm.

Yea post up the details of your swap please.

Yea still have it. Sending a PM

Has the 210 markings. I believe stock open chamber one.

bump

Thanks sent him a PM

I have a L16 out of my '70 521 with 4 speed It ran, could probably use a head refresh. Good compression. Shifts just fine. I have a webber carb for it also. $300 OBO or open to trades

Thanks Bryce, already cleaned up and ready to go.