P.Rubber

Go down towards Vancouver area. Or North. There is PLENTY of mud in WA. After all, we live in a state where it rains 80% of the year. There ought to be mud somewhere :thumbup:

Hi everyone, the choke on my truck is sticking and from cold start I have to put it in gear and drive while she dies. 6 times a morning before she wants to run. My choke plate never closes, ever. How do I adjust it?

What's the price from red line for the Carb? As.far as I can see on site there is no price sheet.

Lol. Why buy a mattress anywhere else....ding.

Where I work, we have sheet rubber, good for gasket material...

Saw this 280 in Vancouver, WA at Costco today.. clean.

Yeah I was just bouncing ideas. I am not doing any major engine mods until i know more about this motor.. like I said I have never owned anything that isn't American car. I know there is a devoted following to datsun/Nissan. And after I bought mine, I became one of those people.

Nice!!! I'll look into it I don't want anything too ricey though.

Where are you.located?

Any ideas on a muffler I should get?

Mine did the same thing. When I did a full tune up the timing was off 10 degrees or something. I got my timing where it should be and it helped. Mine still wants to die at cold start but i haven't got to that yet

I'm the third owner on it and I got it so cheap cause it wouldn't run. Some tinkering and I got her home. Its stock all the way through.

I'm the third owner on it and I got it so cheap cause it wouldn't run. Some tinkering and I got her home. Its stock all the way through.

Yeah that foster store... garbage

Yeah that's probably what I'm going to do. Minus headers. And lots of body work!!!