91b22

Ok I'll get those pics up tonight or tomorrow depending on what time I get home tonight.

Pm replied

I will get some more pics up of it tonight. Wiring is fine. Everything works on the truck, no issues.

Oops, 2,000 obo.

Sold.

So i measured the distance between the rear tranny seal where the slip yoke goes into the trans and the flange of the rear diff where the drive shaft bolts up to... got 61.125" (61 1/8)

bump

like title states, need drive shaft for a 79 king cab datsun 620, destroyed the threads on mine tring to take off the 27mm nut. text me on my phone 253-929-9828. located in the puyuallp,wa area.

Noticed on my datsun 620, the longer drive shaft has a small dent, ill get a pic of it tomorrow, should i be worried about this? also, when you take the rear yoke off the front shaft to replace the carrier bearing, do the front yoke on the slip yoke part, and the yoke the bolts up to the rear of the front drive shaft need to be on the same "plane"? thanks in advance for your help.

good to know.

PCD if I shipped you my towers how much would it be for you to do that?

I've read a few different build threads of people doing this. is there any where I can get this done? I need new shocks on my 620. thanks in advance guys.

thanks for the reply guys. unfortunately Moog has discontinued the drivers side tie rod assembly, but I was able to find one and had it ordered from carquest