Jump to content

Locsteros22

Members
  • Posts

    30
  • Joined

  • Last visited

Profile Information

  • Location
    San Jose CA
  • Cars
    510

Locsteros22's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Ok I read up on thr blocks before just thought there would be another way...thanks much!!
  2. How would I drop the rear end of my 620 because I recently reindexed and changed out the shocks but It only lowered the front haha looks weird right now
  3. What would happen if I used pinto shocks for thr rear as well?
  4. If it's my mounts is there anyway of replacing them without taking out the whole motor? Hhaha I know it's a stupid question but I really don't have access to a crane.
  5. Ok thanks guys I'll check those things when I get home...shoul have checked it since I have the whole drive shaft and tranny disassembled
  6. Finally have time to get on here but with another problem!! Well I recently purchased a 78 620 and now after a few months she started shaking when I accel at high speed...I though the clutch is going out so I changed the clutch which looked gone so it was worth the week of work haha but after I put her back together she still shakes like crazy...any idea what can be wrong guys?
  7. Hey guys I'm looking to buy a 521 for a work truck I live in sj CA of anyone close have one available I'll be happy to pick it up
  8. Yeah it has a red plastic insulation peice with another 8mm bolt on top of that...ok I'll try tha
  9. Yes! Haha but the wire isn't white red since all wiring been replaced...I can't think of anything else can be wrong people I know say something is touching ground but I highly doubt that is true
  10. Well it's the battery wire for thr alt that is sparking
  11. Haha I'm sure the wires aren't switched I'm not that of a noob hahah but it was just like u said black lead in neg and red on alt wire it should read 12v right ? Unless I misunderstood ya haha sorry
  12. Ok so I got a chance of sunshine today and checked my wires and the neg to wire reads 12.3 volts and posi to wire reads 0...and I traced the wire it goes from alt to fusible link to ignition switch. Any other stuff I should try out? I've been cleaning out whatever wires I don't really need to make it easier for myself haha
  13. Yeah my wire harness isn't wrapped all the wires are loose..and the A wire is all red I think it's a 10 gauge wire and it's connected to the fusible link...I'm going to test the wire tomorrow and get back to you thanks for your help!
  14. Ok I narrowed it down to the A wire..could thr wire be too old? Since my new alt tested good?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.