Oxymoron76

None of my local stores have it and cant get it. Checked the pick a parts and nothing. Anyone know where I might be able to get one without breaking the bank? I wasnt able to post in the wanted section so had to post here. Hit me up here

Right now I have a non working Sunpro POS in the tank. Luckily the wiring for the stock sender is still intact. I'll check EGay :-) thanks

I'm in need of the fuel sender. I've tried all the local yards and no luck. I'm in SoCal. You can call or text me 310-766-4416. Thanks

Thanks guys. Nice pics DatzunMike.

My truck just started doing this. I come out in the morning. Start it up. It idles for 30-45 sec and then dies. I go to start it up and it takes a good 2 or 3 timed before it fires. Electronic choke?

None of the local junk yards have any 720's. The regulator spring tensioner came unwound and its driving me nuts. :-)

I'm in need of a need regulator for the driver side door. Mine won't even hold my window glass up anymore. For my 1983 720.

I was driving home tonight and my radio started going in and out, lights & dash went dim, no turn signals and my idle went high. I checked the standard fuses,the battery cables were clean and tight. I went to turn the truck back on. The dash lights come on,radio comes on but no start. It sounds like one of the two main fuses above the fuse is clicking? Any ideas?

I only need the front drive shaft. How much are you looking to get? Thanks!

Ok. Do u have Paypal? Or are you local to Los Angeles?

Bump

I have...... almost all the rubber molding and some of the trim- $20 (2) Nissan front fender badges good condition - $20 (1) Rear tail light with the chrome molding - $10 (1) Under dash cover-metal goes under dash on the driver side -$5 (1) chrome bumer corner piece - $5 I only check my messages here every couple of days. If you want a quick answer or have a question you can call or text me at (310) 766-4.4.16. I'd like to have someone local buy but will try to help with shipping if there is no way of pick up.

Yeah its a Z engine. Thanks for the reply. I appreciate the info.

So when I bought my truck, none of the gauges were working. I dropped the gas tank and installed a Sunpro fuel sender and gauge (which read 3/4 full when full & 1/4 full when empty but that's another thread) :-) I need to hook up the Temp and Oil gauges but don't know where on the engine block they go. Can anyone give me a hand? Thanks in advanced!

Hey again 71Dimer. I still havent received the stickers. Did you happen to send them out yet? Thanks