Jump to content

Esteep

New Members
  • Posts

    24
  • Joined

  • Last visited

About Esteep

  • Birthday 09/06/1988

Contact Methods

  • Yahoo
    jacobosteve@yahoo.com

Profile Information

  • Gender
    Male
  • Location
    Aptos California
  • Cars
    Crown Vic and 71 510
  • Occupation
    Auto/Smog Tech

Esteep's Achievements

Newbie

Newbie (1/14)

2

Reputation

  1. I've had this Can Am Box for a few months now and I'm finally starting my wiring on my 510 and I have a few questions on the S13 sr20det diagrams. First off the orange wire Ecu Pin #36 to Starter Solenoid, Is that wired someplace between solenoid and ignition start? Second I don't have any of the stock wiring for my car no ignition key just some toggle switches with a push start button and kill switch, So there is no Old Coil black/white wire do I replace that with ignition start power as well or just "key on/Switched 12v"?
  2. Nice Set up! is that your stock gas tank? what did you do for the return lines?
  3. Ok, yeah I have about 4 1/2 inches of room, thanks
  4. And it's independent rear suspension didn't read entire reply :rofl:
  5. Approximately how much room should I have from the end of the output shaft to the bottom of my input of the drive shaft?Does that make sense? I have a drive shaft that I'm trying to shorten.
  6. How far does the driveshaft have to go into the output shaft on a 5 speed s13 black top sr20det?
  7. I'm using external pumps, the carburetor/lift 4-7psi pump I picked up at a parts store and I got an MSD pump for my main pump around 40psi, I was trying to avoid welding anything to it but if I have to I will. Yeah I'm going to use 5/16 lines as both pumps, surge tank and filter have 5/16 fittings.
  8. On any of the two circled fittings?
  9. I'm doing an sr20 swap and I want to use my stock fuel tank, my set up is a carburetor/lift pump to surge tank to main pump, but I don't have a return fitting for my return line. So my question, Could I remove the top breather hose from the tank and connect my return line there? How much would it affect my fuel consumption? any one ever try it?
  10. The engine should have the engine code printed on the block somewhere on the right. I posted some pics on an old ad when i was selling mine.
  11. http://mckinneymotorsports.com/prod_DATSUN+510+SR-KA+mount+kit
  12. So here is what I'm wondering. I've been searching for an SR20DET (well more like Window Shopping) and Looks like the cheapest place I've seen these engines are on Ebay. My question is, Is Ebay the best place to get one considering the prices?Please let me know what you think.
  13. PREVIOUS OWNER'S INVOICE FOR THAT SAME ENGINE
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.