L24 510

Im looking for a speedo pinion gear to go in a early 280z 5 speed gear box. I need an orange 22 tooth #32703-86402 or a green 23 tooth #32703-86403. The pinion shaft is 75mm from end to end. significantly shorter than the one that came out of the my 4 speed and dogleg. These gears are NLA from Nissan.

What exactly is this set up? Does it convert an L20 to fuel injection? What is needed to complete the kit?

Does the block have a crack between the water jackets and head bolt hole? What crank is in it?

Make sure you strip the hood first and apply a good self etching primer. Never apply bodo directly over bare metal. Bondo tends to absorb moisture, and it gets trapped under the paint. Bye Bye metal hello rust. Get your supplies at a good distributor such as Finish Master. Not the pink do it center bondo. When doing body work you get what you pay for. Use long block sanders when doing big areas, like a hood. I get my primer from this place SPI. It is illegal in california. That stuff is so good. Im gonna order some tomorrow. http://www.southernpolyurethanes.com/homepage-old.htm Good Luck Scott

I just got my L20 from the machine shop and found that it is cracked. The crack is between the head bolt hole and the water jacket. Is it possible that the machine shop cracked it when taping out the head bolt holes? What do it do?

I have a set of brand new rear floor pans for a 72 2 door for sale. I originally bought them from Mark Grimsley out in Virginia. I did not end up needing them. They are in very good condition, with a few superficial surface rust spots from my fingers. Asking $100. PM me and we can work some thing out. I need the money. Thanks for looking Scott

Where did you get that fuel injection setup? And how is it installed with the ECU and all that stuff? Thats a L20?

I got one. But thanks anyways. Scott

Im looking for a 200mm 6 bolt fly wheel for an L20b. PM me if you have one or know where i can get one. Thanks Scott