Danny

Bump

Sorry guys I can't make it this year the truck is in the shop and I just have so much to do at my house. I will be there next year!!!

No problem in replacing 620 windshield with the dash still in the truck.

It was nice to see everybody out there sorry I didn't get time to talk to most of you I was too busy cooking hope everybody enjoyed the food thanks to Carlos and everybody who brought the food it was a great time

I would but I am going out of the country for a few weeks.

Is anyone doing tee shirts this year?

Due to some problems in the past the Wigwam is out of the question. Last year a few of us stayed at the Hilton just 2 blocks down the street. If we can get some people to comment to staying there maybe we can get a group discount. Hilton Garden Inn 10543 Sierra Ave. Fontana, CA 92337 (909) 822-7300

I always look forward to this.

I just wanted to say thanks to everyone that came out for this year's BBQ / Get Together. It was nice to see some new faces and even the old one's too. If anyone took pictures that are not posted on here please post so that everyone can see everything from the great day of old school cars and trucks.

A few of us are staying at the Hilton Garden Inn just down the street from the park. Hilton Garden Inn Fontana 10543 Sierra Avenue, Fontana, CA 92337 909-822-7300

datzenmike, The problem is that when I built the motor I also changed out the flywheel to an aluminium one and the trans from a 4 speed to a 5 speed that I think came out of a Z don't what year. I replaced the clutch with a stage ll one. Yes this is for my 79 620 KC with the big bore stroker 2.3L.

Thanks guys. The problem is that when I built the motor I also changed out the flywheel to an aluminium one and the trans from a 4 speed to a 5 speed. everything looked the same to my eyes but I do have the nickname Mr. Magoo. The slave looks like it is for a Z but that is okay as I don't run any torsion bars. Now it is 3 + years later and I don't have some of the old parts. Does any have 48.5mm collar?

I am having a problem with the throw-out bearing / collar / fork when I try to put the slave on the trans it wont fit. It is to the point that I have to back out the trans bolts to the motor to put the slave on and then tighten them back up but that seams to put presser on the throw-out bearing. I have measured my collar and it is 52.5MM. I have found that there is 4 different lengths 42.5, 44.5 48.5 and 52.5 so should I go to the 44.5 as it shows to be for a 225mm clutch witch it what I have? Is it true that the 52.5mm is for a 4 speed trans and the Next question is there and differences in slaves as far as the throw goes I know that the hose and bleeder is in difference places but that is okay in my application?

To everyone that went to the BBQ if you have pictures and would want to share them I am looking for them if you would send them to me at danny@planetmars.com or send me a link were I could get them it would be greatly appreciated. Thank You