Jump to content

z24 intake manifold


Tv808

Recommended Posts

  • Replies 5
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

A stock one? Any old '83 and up 720 gas engine found in a wrecking yard. The earlier '81-'82 Z22 engine intake will also work. Offenhauser sells a dual plain intake, or used to, but I don't see the merits over the stock one. A 'want to buy' ad here... http://community.ratsun.net/classifieds/category/4-engine/?sort_key=date_added&sort_order=desc  ... may get results. We don't allow buying and selling on the forums, only in the CLASSIFIEDS. There's a handy link at the top of every page just below the RATSUN.NET logo.

 

 

Are you converting form the EFI to carb?

  • Like 1
Link to comment

no i was installing an empi 38E carb kit but was not able to remove the studs on the intake manifold. they were seized when i tried to double nut them the where just stretching the studs. so i had to cut them off and drill and tap them. as i was doing so i ended up making a mistake and cracked the manifold because i drilled a little too deep. i’m going to eventually put a side draft webber 45 set up but i would like to see how this carb would run in it with the he mods. eventually i would like to use it and modify it to make a blown through turbo setup

  • Like 1
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.