Jump to content

Looking for adjustable upper control arms


Recommended Posts

  • Replies 6
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Well the first thing I would do is take the stock upper control arms, grind the lip off on the top where the ball joint goes, flip them upside down and put the right one on the left, and the left one on the right.

If he still has negative camber then I would lengthen them just enough to be able to align the front end.

Flipping them upside down makes it so the upper ball joints don't bind, since I re-located my tension rods to the rear and I cut off the front tension rod mounts I can lower mine so far the cross member below the oil pan rests on the ground and the ball joints still don't bind, at the moment that cross bar on my 520 is 2 5/8ths inches off the ground, any lower and it hits stuff, right now it only hits the ground when I dive off the back side of the very large speed bumps we have around here if I am driving over 15mph when I hit them.

  • Like 1
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.