Lozer Posted May 9, 2017 Report Share Posted May 9, 2017 I searched and came up blank on these. Anyone have any experience with converting one to work on a 510? 25 spline or 27? Quote Link to comment
G-Duax Posted May 9, 2017 Report Share Posted May 9, 2017 I have imported about 2 dozen of those, and set several up for people. There are 2 versions, one meant to be used with open diff shafts, and one that was meant to be used with the viscous LSD shafts. There are no markings on the outside, so you can only tell by looking in the spline holes. But they are both easily used in the 510. If it's for the open diff shafts, there will be 2 snap rings (actually they are C clips made of round wire), that are at the same depth on both sides. If it's for the Viscous shafts, it will have only one C-clip, and the grove depths differ from side to side. This one will need an additional C-clip to be added to one output shaft. Both styles require C-clip groves cut into the stub shafts, so they match up with the groves/C-clips in the AP. And you will need to plug the center holes. You can do this 2 ways, either by machining a tapered plug that is a press fit, or just use a 10mm bolt and nut with a little sealant. 1 Quote Link to comment
Lozer Posted May 10, 2017 Author Report Share Posted May 10, 2017 awesome so i can use the stock r160 datsun stub shafts for the shur trac just gotta plug the center holes and cut a c clip grove in it. clarity is great Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.