Jump to content

Weber DGV 32/36 using Factory Linkage


Recommended Posts

I've got a 32/36 installed in my 510 with an aftermarket pedal and cable set up.

The cable works fine but I would like to switch over to use the factory linkage.

 

My question is: what are people using for throttle levers?

I don't see anything that weber makes that would work so I'm guessing custom or using the lever from a stock hitachi unit?

 

Here is a screen shot from a video of a gentleman who appears to have the same setup:

 

maxresdefault.jpg

 

Part number 33 is the lever from the Hitachi Carb Below

 

510_011K_1_xga.png

  • Like 1
Link to comment
  • Replies 8
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Bah Humbug!  If you are going cable, use the 620 throttle sector.  If you have the stock Hitachi from a 510, use the "U" shaped fitting from the carb.  If the "U" fitting tilts too much for the stock hook, cut it and use a connector nut to locate it.  If you need a picture, let me know, I have one in my computer.

  • Like 1
Link to comment

Bah Humbug! If you are going cable, use the 620 throttle sector. If you have the stock Hitachi from a 510, use the "U" shaped fitting from the carb. If the "U" fitting tilts too much for the stock hook, cut it and use a connector nut to locate it. If you need a picture, let me know, I have one in my computer.

I have the same carb I plan to use, a pic would be good.
  • Like 1
Link to comment

The Hitachi pulls via cable towards the passenger side of vehicle.  The Weber 32/35 will pull towards the drivers side.  I just used the lever from my hitachi and flipped it upside down cable could pull towards driver side.  Used the Weber bracket to hold the cable.

  • Like 1
Link to comment

The Hitachi pulls via cable towards the passenger side of vehicle.  The Weber 32/35 will pull towards the drivers side.  I just used the lever from my hitachi and flipped it upside down cable could pull towards driver side.  Used the Weber bracket to hold the cable.

NOT!  BOTH carbs pull the same way.  Weber 32/36 DVG

Link to comment

NOT!  BOTH carbs pull the same way.  Weber 32/36 DVG

 

DOH! you are correct.  I flipped the hitachi lever so it pulls from left side so I had a way to mount the cable, since the weber does not have a built in cable mount like the hitachi.  Either way, it works fine.

  • Like 1
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.