Just wondering?

[edekalil]

My friend has a set of I believe 38mm carbs roundtop carbs look like SU type made by Hitichi. He only has the 2 carbs. What other components will I need to make these work.

 

Eddie

[spottedog]

a intake manifold is needed.

[datzenmike]

There were at least two Nissan intakes a K14 intake or 210? Not sure on the 210. You will also need all the linkages and choke cables.

[edekalil]

Thanks

[ByStickel]

All you need to do is to send 'em to me. I have the intake and will get them set up.

 

My first l20b car had them and they were great for street use.

[edekalil]

All you need to do is to send 'em to me. I have the intake and will get them set up.

 

My first l20b car had them and they were great for street use.

My friend dropped off the carbs today so get that intake manifold ready for me. Just kidding, I will post some oics tomorrow in the morning.

[edekalil]

These are the su carbs my friend gave me.

The opening is 1 3/4" .

[Dolomite]

Aren't the square flanges Z carbs? I have the flat tops which are supposed to be nearly identical to the round tops, they have 2 bolt flanges.

 

Edit: 1 3/4 should be 44mm, too much for a 4cyl.

[edekalil]

Aren't the square flanges Z carbs? I have the flat tops which are supposed to be nearly identical to the round tops, they have 2 bolt flanges.

 

Edit: 1 3/4 should be 44mm, too much for a 4cyl.

You are probably correct I really know nothing and did notice what you are saying here till this morning when I took the oics. Any way I got them for free I do have a set of the flat top su setup that should have all of what I need I guess when I need them.

[Sealik]

Edit: 1 3/4 should be 44mm, too much for a 4cyl.

 

?????....Depends on the 4 cylinder. 

 

Those look like the early 240Z 46mm roundtops. The K14 or 220 intake will have to be opened up to 46mm.....and you'll have to profile a set of needles to get your A/F ratio numbers in 'order'.