dpm Posted April 30, 2015 Report Share Posted April 30, 2015 Just rebuilt an A14 for my B210. Started it up yesterday and there is a miss. I have new plugs, wires, cap and rotor. I adjusted the valves after the rebuild. The only thing different now is I installed a Weber carb. Not sure where to start. any help would be great. Thanks Quote Link to comment
EastBay521 Posted April 30, 2015 Report Share Posted April 30, 2015 Make sure all of your wires are making good contact. ive had a loose wire on the coil that caused my engine to miss one time Quote Link to comment
Draker Posted April 30, 2015 Report Share Posted April 30, 2015 Is it missing on the same cylinder or is it jumping around? Quote Link to comment
ericsb210 Posted April 30, 2015 Report Share Posted April 30, 2015 Check timing Check compression Make sure the head gasket seated correctly Check for spark n strength of spark for each cylinder. spark plugs and spark plug wires now a days are often faulty off the shelf. Check all vacuum sources for leaks with Webers we all have to use adapters, very common leak source Clean idle circuits on the Weber (both sides) Check coil Quote Link to comment
dpm Posted April 30, 2015 Author Report Share Posted April 30, 2015 Thanks guys. I will check all of this out tonite. Quote Link to comment
datzenmike Posted May 1, 2015 Report Share Posted May 1, 2015 Pull the plugs, they are a window into the combustion chamber. Is one noticeably different than the others? Fouled? Carboned up? Check the rotor and the dizzy cap on that plug for carbon tracking. Replace if you can. Swap another wire on... does this fix the problem? Adjust the idle mixture slightly richer. 1 Quote Link to comment
dpm Posted May 1, 2015 Author Report Share Posted May 1, 2015 Got it fixed. You guys were right on. Adjusted the carb per Weber instructions, runs great. Thanks again I would not have thought it would be the carb. 2 Quote Link to comment
dat521gatherer Posted May 2, 2015 Report Share Posted May 2, 2015 Now we need pics. Quote Link to comment
datzenmike Posted May 2, 2015 Report Share Posted May 2, 2015 Got it fixed. You guys were right on. Adjusted the carb per Weber instructions, runs great. Thanks again I would not have thought it would be the carb. http://community.ratsun.net/topic/66264-font-size-used-in-postings/ Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.