Javin Posted January 31, 2015 Report Share Posted January 31, 2015 what paint should I be using between now and a real paint job that wont be a mess of stripping when that time comes? i have some spots i want to paint so they don't rust but i don't want to hamper any future paint jobs. the real paint job is likely years off.But wanted to know what the options and opinions are. Quote Link to comment
MicroMachinery Posted February 1, 2015 Report Share Posted February 1, 2015 I'm considering Plasti Dip. Peels right off. 1 Quote Link to comment
Javin Posted February 1, 2015 Author Report Share Posted February 1, 2015 I like plastidip but I am thinking more for rust prevention before I even do that. Quote Link to comment
MicroMachinery Posted February 1, 2015 Report Share Posted February 1, 2015 Maybe rattle can some zincrom primer on the spots you're worried about before applying the PlastiDip? 1 Quote Link to comment
DatMo Posted February 3, 2015 Report Share Posted February 3, 2015 primer. something sandable. It'll be the most beneficial. I'd recommend rustoleum or if you can, finish masters sell a 2in1 primer that's pretty darn great. 1 Quote Link to comment
DanielC Posted February 3, 2015 Report Share Posted February 3, 2015 Car or parts stored inside, or outside? I would go with the primer you plan on using under the final paint. Do your surface prep just like you would, but spray the primer on heavier than normal. If you want specific products, I would use PPG DPLF. But it needs 55 degree surface temp or ideally higher to cure properly. when you are ready to paint, it can be sanded, although it is not the easiest sandable primer, and recoated with DPLF again, and then the painting finished. Read the data sheets on any product you use 1 Quote Link to comment
mcordero8 Posted February 8, 2015 Report Share Posted February 8, 2015 If rust is what you are worried about POR-15 is the way to go. I believe it comes in black and grey. Good luck. Quote Link to comment
TENDRIL Posted February 9, 2015 Report Share Posted February 9, 2015 Por is uv sensitive Quote Link to comment
shacks510 Posted February 9, 2015 Report Share Posted February 9, 2015 Por is uv sensitivePOR has a UV tolerant overcoat that can be applied to UV exposed surfaces. I'm sure this isn't cheap either though, considering the $50 a quart. I've read this online, and it is true to my experience. Primer is of course porous to allow for paint to grab onto it, which also will absorb moisture. A rust stopping primer (Rustoleum in my case) does not stop rust of you use it by itself. I'd say primer it, and paint over that with some cheap paint, just so there isn't a surface for water to absorb into and rust again. It should be easy to chemically strip it before a real paint job. You can plastidip over the primer. Dip comes off primer, but it'll be more of a tug to remove it. If you don't use enough coats, it will not peel off in one big sheet like you see online and becomes a real PITA, even on glossy surfaces. Ask me how I know. Dip isn't cheap either. At $7 a can, you'd be better off with some cheap rattle can paint. A little more work later to prep it again, but would be worth it in my eyes, unless of course you get a ($300?) DIY dip spray setup. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.