bob3d Posted August 25, 2014 Report Share Posted August 25, 2014 I had some wear in my primary throttle plate on my 78 b210. DCH306.I fixed it by wrapping the shaft on the linkage side with .0015 feeler gage shim. It stayed in place and worked. The idle smoothed out. Before I fixed it I put an 8mm precision ruby sphere into the throttle shaft holes to check the size. It went through but stopped before entering the throttle chamber on both sides. There must be some deposition there close to the throttle plate. I left it thinking it was helping to reduce the leakage. Quote Link to comment
datO))) Posted March 27, 2015 Report Share Posted March 27, 2015 I'm gonna try it. Thanx man Quote Link to comment
ggzilla Posted March 27, 2015 Report Share Posted March 27, 2015 Do you mean the throttle shaft bores? I've seen a throttle plate worn, but not sure how it would be fixed. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.