Jump to content

Floor Rot....


ryzart

Recommended Posts

Hey guys i pulled up the vinyl that was on the floor of my truck and uncovered this mess. I looked under the truck and i didnt notice it. Guess it was too dark or something because now with the interior gutted it is really easy to see from underneath. I looked under the seat and behind it and the floor looked great so i taught it was fine. So now what do i do ? How would some of you guys go about repairing this ? Initially i wanted to cosmetically clean up the truck, repaint, interior redo, bag it, etc. So in my eyes this was looking like a pretty cheap build for me and all stuff that i can handle. Now this i am not sure i can handle and would need someones expertise to repair this properly which is going to turn into big $$$. I also tore into the truck so much that i dont want to put it back together just to try and get rid of it..which i wouldnt get shit for it anyway. Not sure how long after i am done with the truck i would plan on keeping it for so a cheaper alternative way to fox this might be in the picture. Any opinions ? Silly of me to think a truck that is almost 30 years old and on the east coast has no rust/rot on it !! Please help !!!!!

 

2iky0rp.jpg

 

14n2p36.jpg

 

jrczg1.jpg

 

2cxivwk.jpg

 

2qkjk37.jpg

 

21d4bps.jpg

Link to comment
  • Replies 5
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

  • 3 months later...

I have had 3 720 trucks and all are bad about this. Bet on any 2x4 truck it has needed or needed ball joints several times. But to what is available you find sheet metal and cut out pieces and weld in new ones. Depends on what tools you have to use to how hard it is. A cheap flux core welder is your best start. A flux core seems to weld better on dirt/rusty/painted metal than one with a bottle. What ever saw you have to cut pieces of metal or a floor pan from another truck. Take the gaurd off a 4 1/2" grinder and put a 5" cutoff wheel on it and it will make easy work to cut out a pan in pieces if you are near an outlet. Personally i have choices of torch, sawzall, cutoff wheels and more. Just start patching a little piece here and there and you will get better as you go. A big piece would not be much harder than a small one if you take your time and try after you do one or two small jobs. Could just sand the rust out weld on a reinforcement or two or more and then bondo the hell out of it. Looking at all the rust on the outside of most of these kind of hinted to the under side being ruff.

 

Good luck just takes time.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.