anynoe have a picture of the blinker relay for a 240z?

[City Hunter]

Wondering where it's at and what it looks like. I have 3 wires sitting over by some other relay that are not hooked up. It doesnt sound like I even have a blinker relay hooked up.

[datsunaholic]

It's round, with 2 wires set at a 90 degree angle in a plug. There should be 2- one for the signals, one for the hazards.

 

The Hazard switch (in the console) has to be hooked up for the blinkers to work, as they feed through it.

[City Hunter]

My hazards are working, just not the blinkers. I'll take a look. Any idea what has 3 black wires and sits near the hood latch under the dash? Looks like it has 2 bullet connectors and a spade I think.

[datzenmike]

Try working the switch repeatedly a dozen times to shine up the contacts. Switch the hazard and the turn signal flasher units and see it that switches the problem.

 

Find the fuse box and check the second fuse back from the front (20 amp) Hard to understand the diagram but theres a 10amp on one side and a 20 on the other. Check them all to be sure. If it's blown or making poor contact the emergency flasher has no power.

 

Does your horn work????

[nismopu]

just stop by I got a spare switch laying around somewhere. peace.

[City Hunter]

kyle you liar, I drove all the way down to vancouver and had to help josh getthat pile of shit subaru on the tow dolley.

 

You shoulda been there though. First time we tried to get it on we had it jacked uip with a floor jack and I just hauld ass in reverse to try to get it to slide up on the dolley, ended up running over the floor jack, lifting the whole drivers side of the dolly into the air, and the subaru feel off half way and the fpassenger side of teh duby was all cockeyed on the dolley about 4 ft in the air lol. We managed to get that piece of junk back though.