fastdadd Posted March 19, 2018 Author Report Share Posted March 19, 2018 ok i have the motor sitting in jack stands where i want it now i can start making the motor mounts 1 Quote Link to comment
fastdadd Posted February 3, 2019 Author Report Share Posted February 3, 2019 (edited) i am not dead yet...pics to follow Edited February 3, 2019 by fastdadd Quote Link to comment
fastdadd Posted February 3, 2019 Author Report Share Posted February 3, 2019 (edited) getting the motor mounts sorted out tomorrow i will get the trans mount done and then on to whatever is next on the list Edited February 3, 2019 by fastdadd Quote Link to comment
fastdadd Posted February 3, 2019 Author Report Share Posted February 3, 2019 the motor is sitting in the engine bay all on its own now onto mounting the trans 1 Quote Link to comment
datsunfreak Posted February 5, 2019 Report Share Posted February 5, 2019 Looks like it's leaning too far to the right, but the oil pan says I'm full of shit... Quote Link to comment
fastdadd Posted February 5, 2019 Author Report Share Posted February 5, 2019 2 hours ago, datsunfreak said: Looks like it's leaning too far to the right, but the oil pan says I'm full of shit... i know that fucked with me for quite some time...finally deiced if the pan is flat then the crank is also Quote Link to comment
Dguy210 Posted February 5, 2019 Report Share Posted February 5, 2019 Oh God does this all look too familiar. Welcome to the wonderful world of trying to shove a KA into an A series car....may God have mercy on your soul. Looking good so far though. Just a heads up that the header will most likely not fit (clear the steering box). I had similar ideas for the crossmember, but went a different way when I decided to shove it into the B110 instead of the B210. May be useful (mostly on what not to do): Similiar to above link but with a few extra pics and commentary: https://www.nwdatsuns.com/viewtopic.php?f=10&t=63&start=200 Quote Link to comment
fastdadd Posted February 5, 2019 Author Report Share Posted February 5, 2019 11 hours ago, Dguy210 said: Oh God does this all look too familiar. Welcome to the wonderful world of trying to shove a KA into an A series car....may God have mercy on your soul. Looking good so far though. Just a heads up that the header will most likely not fit (clear the steering box). I had similar ideas for the crossmember, but went a different way when I decided to shove it into the B110 instead of the B210. May be useful (mostly on what not to do): Similiar to above link but with a few extra pics and commentary: https://www.nwdatsuns.com/viewtopic.php?f=10&t=63&start=200 i have been following those...i have an aftermarket header and not afraid to cut it 1 1 Quote Link to comment
datsunfreak Posted February 7, 2019 Report Share Posted February 7, 2019 On 2/5/2019 at 12:17 PM, fastdadd said: i have an aftermarket header and not afraid to cut it This made me laugh out loud... Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.