Jump to content
  1. General

    1. General Discussion

      Talk about anything.

      538k
      posts
    2. Events

      Upcoming events.

      89.3k
      posts
    3. Project Datto

      A place to discuss Datsun projects.

      215k
      posts
    4. Datsun Stories

      Share a Datsun story.

      10.5k
      posts
  2. Datsun Discussion

    1. Cars

      A place to talk about Datsun cars.

      153.8k
      posts
    2. Trucks

      Talk about your Datsun truck.

      284.2k
      posts
    3. Other Datsuns and Nissans

      A place for all other Datsun and Nissan vehicles which don't fall into the main forums.

      15.6k
      posts
  3. Technical

    1. General Technical

      A place to discuss technical aspects which aren't necessarily covered in a specific forum.

      26.2k
      posts
    2. Engine

      If you don't know what this is, you probably shouldn't work on a car (or drive it even).

      85k
      posts
    3. Drivetrain

      This stuff makes your wheels turn.

      22.2k
      posts
    4. Suspension

      Springy sort of stuff.

      15.7k
      posts
    5. Electrical

      Wires and such.

      24.3k
      posts
    6. Brakes

      These things make your car stop!

      10.2k
      posts
    7. 17.1k
      posts
    8. Wheels and Tires

      Round. Rubber.

      10.1k
      posts
  4. Write Ups

    1. How-To

      Submit a "HowTo" write-up.

      8.2k
      posts
  5. Classifieds

    1. Classified Ads   (318,592 visits to this link)

      Redirect to the classified advertisements.

    2. Discussion

      Discussion about classified ads.

      1.8k
      posts
    3. 164.4k
      posts
  6. Off Topic

    1. Non Datsun Cars and Projects

      Discuss your Non-Datsun cars and projects.

      24.3k
      posts
  • Upcoming Events

    No upcoming events found
  • Posts

    • I do not own a 1911 of any style, which I really should change at some point.   However, I do own this in 45 ACP and damn does it shoot beautifully, custom Cerakote job and my bedside gun (well, one of them).     His and Hers S&Ws, although the wife doesn't shoot it very much (she tends to prefer the 10/22 more than anything).      
    • Hello ratsun community,  I'm sure this has been covered already but I'm not finding what I need to know. My 79 620 k.cab's heater isn't fully  functioning.The defrost nozzle/vents for the windshield work, and blow heat.The Rt./Lt. Vents ,close to the  doors do nothing, no heat and no air flow.Finally, the vent(s)  below the dash (center) , where you  push the know in for vent Does work,  however NO heat ,even though I've got heat Uptop through the windshield vents.I am pretty sure that in the past ,the vent below dash (center), when pushed in I would have  heat there as well..Could this be do to a resistor or perhaps the heater core itself?..I am contemplating removing the whole  heater assembly to inspect, clean,lubricate cabling and or refelt , blah blah ect.Mabye  I'm imaging heat coming from the lower vent, it's been a while and the side vent never worked.This 620 is NOT A/C equipped..Thank you wise ones..
    • Hello Ratsun, This is a question that with enough time, I could likely find the answer, but I am hopeful someone might save me some time as they already discovered, or know, the information.  The Z24 head has two valves, the KA24E head has three valves--will either of the Z24 valves interchange with any of the three KA24E valves? If not right off, then perhaps with minimal modification? Or are the valves of the different engines, very different.  Thank you
    • Putin was a KGB agent. I doubt he's a puss. And just to make things clear, I don't like him or support what he's doing.
  • Recent Status Updates

  • Adverts

  • Member Statistics

    • Total Members
      49,139
    • Most Online
      2,169

    Newest Member
    Pooklord
    Joined
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.