All Activity

Tucker not a comedian and definitely not funny but those who shit on him are.

The pins on the light switch are below. The 8 pin plastic plug wire colors... Pin#...... Plug wire 36 ......... Red/Blue power from the fuse box 37........... Red/Yellow to all marker/parking/license/dash lights

You could replace the name Tucker with the name Maher in your post and the statements would still be 100% accurate. Not sure how you don't see that. Aside from drilling leftist propaganda on his show before woke was even cool. You know he also has his own podcast where he has no script right?

Yes I noticed that but I was referring to the switch inside. I don't know which pins are for the park lights since there's this community I need to pass to get to farm which requires you to have the park lighta on during the day and I've been stop by the patrol of the community since I have those wired with the headlights and they say it's only the sides that needs to turn on not the headlight since I have led lights so they say it's "distracting". What I've done these days y just disconect my low beams so they don't turn on but I am tired of that so I wanted to qirw it so they work like they supposed to with the switch but I can't find those pins lol

Why would low sperm count matter? unless making babies. I'd be more worried about low T.

Left front lights... The amber combination lamp has... Green/Red to the turn signal bulb Red/Yellow to the parking lamp bulb and also the side marker lamp Black ground for both. If the other side works then the light switch is working as it powers all clearance lights front and back and all running or parking lights front or back. If all front left side not working then possibly the ground is bad. If one lamp not working then bad bulb or the ground to that bulb.

Hello people well I've been having this problem, until now I got time to mess around with the 720's light switch. I've been following a diagram I found online (because a manual that I ordered online cane water damaged) I shows me the pins for the left and right head lights. On the left 8 pin conector I noticed they are 2 pins thatthe diagram didn't say anything about but I had the idea of them being the park lights but i am not too sure. I've tested for continuity but they don't have I am not sure if it's the switch or if I am wrong about them being the park lights. Where do I locate Any plug or pins for the park lights.

Unless they have broken or failed I would leave them. Nothing wrong with a stock coil. An after market coil is likely inferior quality. I've seen several manuals and I can't figure it out. Get a volt meter or a test lamp. Pull the first fuse on the far left side of the fuse box, this removes power from the exhaust coil wire. Test the wires. The one with power in the intake coil wire. Plug the fuse back in and test the wires. The second wire that now has power is the exhaust coil. With the power wires identified, the other remaining two wires go to the - or negative sides of the coils. Coils are identical, they fire together. Doesn't rally matter if you mix up the coils.

Maher is a stand up comedian making fun of political absurdity in general. Carlson is a right wing media personality posing as a journalist. Your assumptions may not be correct, but they're always predictable. I disagree with his position on Trump/Putin/Russia/Ukraine/NATO/Climate/Morality,etc His continued defense of Bush Jr after his inept failures in Iraq, Afghanistan, and adequate regulation of the mortgage banking industry. His nut sack laser did not cure low sperm count, but he made lots of money off his loyal fans. I agree that Pelosi and Newsum are corrupt bags of baboon tante. I agree we need stronger boarder control and modern immigration reform. The woke movement is illogical as a rabid dog with low estrogen levels, who identifies as a gender fluid cat with a vegan diet, and an allergy to non-gay peanut M&Ms. It's easy to see that Tucker's fake media persona is about making money. I've watched his infomercials, propaganda validation interviews, and broadcast segments on PBS, CNN, MSNBC, and Fox. As for calling him a douche, after 20 years of watching him shit on anyone in his cross hairs, IMO he's earned the man douche #1 award 10 X over. Most of the time, I either doubt that he's actually a conservative, or I'm 100% sure he's on the opposite side of reality.

I'm replacing coils on intake and exhaust coils. I'm showing a "BR" wire and "WL" wire for intake but manual doesn't show which one goes to positive and which one goes to negative. Same for exhaust coil "BW" and "R" wire but which ones go to positive and which to negative. Please advise. Thanks

I'll swap over some of the jets tomorrow and update y'all then. Thanks!

I haven't run a gauge on it, no. It claims to be 2.5-3 psi. I have it wired to a switch and even with it off, there are no changes in how the truck runs.

make sure you have a good ball joint seperator like this one the pickle forks do not do the job at all but I did have to cut the stud on the lower joint with a angle grinder to get it to push on it straight. Make sure you have a extra jack or something though to move the bottom control arm to help get the bolts lined up for the ball joint. And no you dont have to touch the end on differential, like bottomwatcher said just pop off the snap ring and the axle should slide out the hub.

Probably a dumb question but have you checked the fuel pressure at the carburetor? Weber instructions say it needs a constant 3-4 psi.

Leave the diff side alone. Just the snapring on the axle assembly and the hub will slide right off.

Some 'stuff' just shows up on line. Who would search that out???? (ok it was " show me more cunt's like The View) I saw Tucker's name and they were shitting on him so it was amusing.

IZRL on a roll today. WTF would someone be searching for to find those two bimbo's bickering about somebody that has no influence over their lives whatsoever ? How anybody could watch that is beyond me.

I disagree on his choice of tie. Do you need reasons to dislike someone? I've watched him before but not much interested in what he goes on about. After that Russian propaganda and history lesson not at all.

Look at the jet for blockage. I don't think it's far enough different to not run as you describe. More like, lots of air no fuel. Swap the china 140 main jet in.

Yes.

I agree it isn't #1. But it is up there on the list. The only experience i have with something "similar" to law enforcement. Is I was a security supervisor at a casino for 4 years. I know what you're thinking "hahaha rent a cop". But ask anyone who has ever been a security officer at a casino and without a doubt they will tell you. Being security at a casino is no joke. Anyway, all that to say, I know the importance of "verbal judo". Doesn't change the fact that you have to be proficient with the tools you were issued in that rare occasion when you have no other option. And to your comment about letting officers use a 9 if they want to. I'm not a 100% sure but i don't think they are given a choice but to carry the 9 they were issued. At least not here.

Ya, furniture dolly weight ratings are a lot like compressor or vacuum cleaner HP.

1000lb rating. They had about 850 on them and taco'd. lol. I then replaced them with new ones, with additional wood support up top... and the castors failed. So... not 1000lb rated. I got a kick out of it.

I'm gonna go out on a limb and say that neither of you have ever sat down to actually listen to Tucker. Which tells me you hate Tucker for the mere reason that he's on the opposite side. Bet you can't tell me 3 things you disagree with him on ("he's a douche", doesnt count by the way, paradime). And you can't tell me 3 things you agree with him on. No cheating, if you can't just name 3 of each right off the rip without Google, it doesn't count. Bill Maher is probably the equivalent of Tucker but on the left. He's clearly on the other side. But I've watched enough of him that I can at least list a few things I disagree with him on, and I can list a few things I actually agree with him on.

I'm working in Ontario. Went to Meridian to goof off. Driving by ya. Hi; bye.